Article description - Marantec Comfort 257 garage door operator system with control x.21 for underground and collective garages
Motor unit Control 257, pre-cabled, separate control unit Control 53, pre-cabled, Universal mounting kit for up-and-over doors and sectional doors
Electrical details:
Nominal voltage: 230 V
Nominal frequency: 50 / 60 Hz
Power consumption: 1 A
Power input in operation: 0,2 KW
Power input stand-by: 3,6 W
Operation voltage (duty cycle): KB 5 Min.
Control voltage: 24 V DC
Protection categorie: (Motor unit) IP 20 / (Control unit) IP 65
Protection class: I
Mechanical details:
Push and pull force: 1.000 N
Door travel speed: 140 mm/Sec.
Opening time (door-specific) approx: 18 sec.
Function:
· Reference point technique
· Soft start/soft stop
· Push-open security device
· Anti-blocking device
· Excess travel stop
· Release from inside
· Connection for pushbuttons, code keypads and key switches
· Connection photocell 'Open' and 'Close'
· Connection closing edge safety device 8,2 kOhm 'Open' and 'Close'
· Connection traffic control Control x.301
· Automatic cut-out 'Open' and 'Close' separately programmable
· Partial opening can be programmed
· Door travel speed 'Open' and 'Close' separately programmed
· Soft run position 'Open' and 'Close' separately programmable
· Soft run travel speed 'Open' and 'Close' separately programmable
· Automatic timer function
· Signal relay for signal light 230 V
· Signal relay for:
· Wiping impulse / 3 minutes light
· Final position message
· Alarm system
· Malfunction message
· Error message
· Reset function
Application: · Operator system for garage doors - industrial use
· For up-and over doors up to a door width of 6.000 mm and a door weight of 200 kg
· For single-walled sectional doors up to a door width of 6.000 mm and a door weight of 200 kg
· For double-walled sectional doors up to a door width of 6.000 mm and a door weight of 200 kg
· For retractable up-and-over doors and canopy doors up to a door weight of 200 kg
· For maximum 50 parking lots / 100 cycles (equivalent to class III RAL GZ 740, 80.000 cycles)
· For operator rails with roller chain or toothed drive belt