CARDIN manual transmitter S449 433.92 MHz, 2-channels, black and grey housing, black keys, of impact-proof plastic, 2 pieces 3 V (6V) lithium batteries CR2032

There is a chance the receiver has been locked by the fitter in which case you cannot program the new manual transmitter. You have turn to the supplier of the receiver.

If the receiver has not been blocked, proceed as follows:

Coding a manual transmitter
You can encode your new manual transmitter with either an already working manual transmitter or with a radio receiver.

I ° Coding with an already working manual transmitter
Take an already working manual transmitter and the new manual transmitter. Position yourselves close to the operator pulse controlled by the manual transmitter. (Stand in the destination field of the radio receiver.). Take the already working manual transmitter: Press the hidden key (small hole on the hand transmitter) with a paper clip. The receiver gives a short acoustic signal. Press one of the keys of the already working manual transmitter = a short acoustic signal sounds from the receiver. The receiver remains in the learning mode for 5 seconds. Take one of the new manual transmitters and press the key you want to register. 2 short acoustic signals come from the receiver to confirm registration of the new manual transmitter. You can register several hand transmitters one after another.

ATTENTION: After 5 seconds in idle state there is a long acoustic signal from the receiver to announce the learning mode.