Smolka Tor- und
Antriebstechnik Berlin

Hörmann Remote control HSM 4-channel 26.975 MHz =green buttons

Article description

Hörmann Remote control HSM 4-channel 27 MHz (exact 26,975 MHz). Dimension 37 x 60 x 12 mm. This remote control will be sent with battery and instructions.
Attention!!! This remote control always has green buttons. Only command if your Hörmann remote control has green buttons too!!!

Attention! Check the frequency on the quartz!!! This remote control is also available with frequencies 27,015 and 26,995 MHz

Coding of a remote control by use of an already functioning remote control.

ATTENTION: Coding opens door.
In order to control the door and in order to prevent unexpected consequences we recommend to stay in the garage while coding.
1. Take your already functioning remote control and press on one button.
2. Now please take the new remote control and act as follows:
- in case of remote controls with blue buttons: parallel on collision
- in case of remote controls with green or grey buttons: head on head on collision
3. Press on your new remote control the same button and please keep on pressing. The LED flashes with low frequency for 4 seconds, then with higher frequency and shows successful coding.
Release all buttons .
4. Repeat this process with every button on your remote control.
5. Test your new remote control

Coding of a remote control with green buttons by use of an old and not working Hörmann DH remote control.

1. Please open the battery case of your old Hörmann DH remote control.
Pay attention to the 10 mini interruptor's position: ON or OFF.
2. Open the byttery case of the new remote control with green buttons.
Press with an acute item on the small button which is placed on the left side above the battery (2 red circles in 'other images')
The control lamp of the remote control flashes.
(Coding should follow few seconds after pression of the small button. Please start again if the control lamp stops flashing before the end of the coding.)
Code your remote control with an 10 time pression on the button:
- the upper button of your remote control which corresponds to the mini interrupter's position ON
- the lower button which corresponds to the OFF position.
After the 10th pression the control lamp will accelerate its flashes.
Test your new remote control.

Coding by use of a radio receiver.

For remote controls with green or grey buttons.
(connection of the green receiver = -(20), brown = (5), white = cte (21))
ATTENTION: this action delets all remote controls which have been saved before.
Look for the radio receiver of your drive.
(small grey box, circa 1/3 of the size of a cigarette packet).
Press the button of your radio receiver. The LED of the receiver illuminates and blinks slowly.
Please depart in 3m distance of the receiver. Take your new remote control and press one button. The LED of the receiver flashes with higher frequency while still pressing the button. Release the button of your remote control. The control lamp continues flashing for some seconds and finally extinguishes.
Test your new remote control.